Release Notes for Bobcat 265 Models (Release T):

Bug Fixes:

• Low voltage output for CV process on Bobcat 230

Includes these previous software revision changes:

Release S

• Adds Spanish and French language options
• Adds metric and imperial units options
• Spool gun run-in can now be disabled
• Added Commanded engine RPM speed to troubleshooting screen
• Bug Fixes:
  • Voltage feedback sampling improvements
  • Increased DC Bus High error trip point
  • Fixed engine speed transitioning to high speed when selecting Spool Gun or GTAW process

Release R

• Layout update to System Info Screen

Release Q

• No change for Bobcat 265 Models

Release P

• Update to factory default settings
• Bug Fixes:
  • Fixes engine hour counting issue
  • Correct heading for maintenance popups
  • Corrections to description texts

Release N

• Adds Vanguard engine option
• Bug Fixes:
  • Fixes default maintenance hours

Release M

• No change for Bobcat 265 Models

Release L

• Battery Charge updates
• Bug Fixes:
  • Fixes productivity tracking
  • Service log timestamp fix
  • Maintenance levels not properly resetting

Release Notes for Bobcat 265 Air Pak Models (Release T):

• No change for Bobcat 265 Air Pak model

   

Includes these previous software revision changes:

Release S

• Adds Spanish and French language options
• Adds metric and imperial units operations
• Spool gun run-in can now be disabled
• Added Commanded engine RPM speed to troubleshooting screen
• Bug Fixes:
  • Fixes for compressor foldback during gouge operation

Release R

• Adds DSP version to System Info Screen
• Bug Fixes:
  • Improved weld foldback and engine response from idle
  • Fixed nuisance "Boost DC Bus Out Of Range" error
  • Fixed 14-pin remote contactor signal detecting OFF when engine RPM dips

Release Q

• No change for Bobcat 265 Air Pak model

Release P

• Bug Fixes:
  • Fixes default maintenance hours

Release M

• No change for Bobcat 265 Air Pak model

Release L

• Added air valve current feedback to troubleshooting screen
• Bug Fixes:
  • Fixes productivity tracking
  • Service log timestamp fix
  • Maintenance levels not properly resetting

Update Notes

1. Update is for serial numbers manufactured starting with MK071019R only.  Units prior to these serial numbers cannot update the weld module software, so the update will not work correctly.
   
    
2. For units that meet the serial number requirement, the update will end with a "WELD COMM" error on the display. The update will be loaded properly, but the weld module does not start.  To remedy this, simply turn off the engine, wait for 10 seconds, and restart.  The unit should operate properly.

Release Notes for Bobcat 200 Air Pak Models (Release M): 

• Bug Fix: Customer CAN message could conflict with control board boot loader
• Bug Fix: Incorrect air compressor hours in summary file