Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 3 of 3

Thread: Gauge confusion

  1. #1
    Join Date
    Feb 2007

    Default Gauge confusion

    Hi all,
    I had a gauge that measured CFH which broke. The guy at the welding shop sold me a gauge that measures L/min. I found the conversion rate to be 2.2 or something, which is fine.

    But then I noticed that the lowest L/min mark on the gauge was 5, which is around 10cfh. Anything below that, I won't know what the flowrate is...I can't afford a floating ball setup. Should I return this gauge?


  2. #2
    Join Date
    Jan 2006
    Albuquerque, NM


    If it were me I would take it back and get a " floating ball guage" (flowmeter) from HTP for about $45, I have one on my tig setup and seems to be of good quality.
    Regards, George

    Hobart Handler 210 w/DP3035 - Great 240V small Mig
    Hobart Handler 140 - Great 120V Mig
    Hobart Handler EZ125 - IMO the best 120V Flux Core only machine

    Miller Dynasty 200DX with cooler of my design, works for me
    Miller Spectrum 375 - Nice Cutter

  3. #3
    Join Date
    Feb 2007


    Thanks, I didn't know you could get them that cheap!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Warning: Function split() is deprecated in /mnt/stor3-wc1-dfw1/357822/357839/ on line 77

Welding Projects

Special Offers: See the latest Miller deals and promotions.