Just purchased the above unit. Great condition except it wont idle down after stopping the bead. Stays at the welding RPM. I was told by the seller that it had a bad circuit on the board. Does anyone have a similar machine that has experienced the same problem?
Results 1 to 2 of 2
Thread: Idle Problem Miller AEAD 200LE
-
01-22-2007, 07:52 PM #1jh1102 Guest
Idle Problem Miller AEAD 200LE
-
01-22-2007, 08:15 PM #2
Guest
- Join Date
- Dec 2005
- Location
- Lodi, CA
- Posts
- 1,495
First thing I'd do is check the voltage at the battery when it's running, see if it's charging or not (should be 13+ volts). This happened several times with my trailblazers (Onan engines), every time it was the rectifier/voltage regulator fried, battery voltage (12 volts or less) by itself wasn't enough to operate the idler electromagnet.
Reply With Quote
