Why does my wire burn before it comes out the contact tip?
Results 1 to 3 of 3
Thread: Spool Gun Problem
01-19-2007, 04:53 PM #1donitarae Guest
Spool Gun Problem
01-19-2007, 04:59 PM #2
too high on the voltage ....too low on the wire speed or feeding problems......I'm sure there are more.......more info would help as well.
MikeGeorge W. Bush was saving your butt whether you liked it or not!
Fear is temporary, regret is forever
HH210 with SG
01-19-2007, 05:02 PM #3
I assume you are using alum wire? Make sure the hole is the proper size and make sure the wire slides thru the tip hole when the tip is off, if it is tight go to the next size tip. I ran into problems with the proper size tip it seems they were made too small. Try some more wire speed....BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below.