I built this bed over a year ago. I used 14G for the tool boxes, 1/8'' deckplate for the floor, and 3/16'' for the workbench. mounted just under the bench is receiver tube so I can put the vice on and off. I lost the pic that shows the rear of the bed, but I have a 5hp gas air compressor mounted in it. The welder is a Miller trailblazer 280. I could only work on it part time, so it took me about 2 years to finish.
Results 1 to 4 of 4
Thread: sevice bed
Threaded View
-
11-08-2005, 03:40 PM #1
Member
- Join Date
- Nov 2005
- Location
- Buhl, Idaho
- Posts
- 53
sevice bed
Last edited by trevwelder; 02-07-2006 at 07:32 PM.
Reply With Quote
