Ok so I tried to weld 035 SS plates together today and it looks terrible between the burn through and poor penetration I did see a little weld that looked good but the back side of the weld looked like crap.
That beeing said what would you guys set a syncrowave 200 at to get good welds and how much tungsten needs ti stick out of the cup?
I have the red tungsten sharpened with a flat point.
tried using about 20 amps on AC PPS at 3.
Results 1 to 4 of 4
Thread: .035 SS + SyncroWave200
11-29-2006, 10:09 PM #1Junior Member
- Join Date
- Nov 2006
.035 SS + SyncroWave200