Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 3 of 3
  1. #1
    winston Guest

    Default Legend AE200 help

    A few months back I purchased a 1995 Miller Legend AE200 with an onan motor. It was sold by a large equipment dealer and was "inspected and repaired" by the company that sold it. Shortly after I purchased it (one week, 2 hours of operation), it stopped making a consistent spark and wouldn't charge the battery. I took it in to be looked at by a shop, and they told me that my magnets on the flywheel had let go and would need to be replaced. The total cost was about 2/3 of what I had paid for the unit and I couldn't justify spending the money. Is this something that a repair shop should do, or is it something that I can get the part for and do it myself? (I am fairly mechanically inclined.)

  2. #2
    Join Date
    Feb 2006
    Hortonville, Wisconsin


    Winston, If you pay for shipping, I have a spare flywheel from an Onan Performer engine. Let me check first in the books and see if the one I have will fit. The one that I have is from a Legend with an 18hp engine. Let me check and I will get back to you. If you want to PM me I will give you my phone number to call.
    Spectrum 375 plasma cutter
    Spectrum 2050 plasma cutter
    Millermatic DVI with 3035 spool gun
    Millermatic 350P with 30A spool gun
    Dynasty 300DX Tigrunner
    Miller Legend
    Miller Pipepro 304

  3. #3
    Join Date
    Feb 2006


    It`s not hard to change,if you don`t have a puller use a small pry bar and put it behind the flywheel on the key way side.put light pressure on it and tap on the crankshaft with a hammer just be careful not to damage the threads putting the nut back on so it`s flush with the end of the shaft usualy works.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Warning: Function split() is deprecated in /mnt/stor3-wc1-dfw1/357822/357839/ on line 79

Welding Projects

Special Offers: See the latest Miller deals and promotions.