I recently picked up a barely used syncrowave 180 SD TIG project. The machine stick welded but the TIG function does not work, so I pulled the board. I found a hot glue covered jumper "repair" on the smaller of the two boards connected with a ribbon. I am not sure what went on here, since there does not appear to to be anything burnt or visually blown. I am sure some component has failed, but the damage may have been contained to just this area since the Stick side still works. I think the board can be repaired if I had a schematic of it or even a picture of the traces on the smaller board. A new board is not really an option for me since the ones I have found are $500+ and my budget is very limited.
Any help is greatly appreciated.
The serial # kk324409
The stock #903600
Results 1 to 1 of 1
05-25-2014, 11:00 AM #1Junior Member
- Join Date
- May 2014
Syncrowave 180 SD Control board problem