Hello all
So I have new question I have a TB 302 DC only unit, and today I tried to scratch tig and it wouldn't work it just melted the tungsten in an instant. What I have done with my buz box is just attached my gas block and tig torch to the stinger and the ground to the work piece. Yes there is no way back off on the heat but I have done this for years. I was trying to do the same with the TB but I think I am off some where, any advice. I would like to do AL too,, so I may just buy a dynasty and plug it in to the 220 side and just be done with it. what do you guys think
thanks