Hi guys, new here
I have a miller 252 mig welder.
a buddy of mine that owns a mill write company have me a prince
alum spool gun.
the spool gun does not hook right up to my welder.
the gun came with a unit wired in line called the "torpedo"
after a inquiry to mk products, the said the torpedo was an "interface" module that allowed the gun to work on miller welder a using the 14 pin connector.
the connector is just slightly to big to fit the receptacle on my welder.
of course they wanted to sell me a stand alone module to control the gun for 500$
I will only use the gun a handful times around the garage a year.
if anyone knows how to adapt this to my welder than would be great.
i think I have the correct wire diagram for my miller welder.
if I have to buy the right connector for the welder and put it on the gun wiring harness that is fine.
I would just need to know what wires go were.
Results 1 to 5 of 5
Thread: Prince spool gun to miller 252
05-16-2014, 01:12 PM #1Junior Member
- Join Date
- May 2014
Prince spool gun to miller 252
05-16-2014, 07:11 PM #2
I wouldn't hook a "prince spool gun" up to anything. They are junk in my eyes. Just my thoughts...BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Spool Gun conversion. How To Do It. Below.
05-17-2014, 09:40 AM #3
I won't hook up that piece of C*R*A*P to ANYTHING!! I toss em brand new into the garbage bin.
Go on Ebay and get yourself a 15 or 30A Miller spoolgun. I hook these up to all brands. Most dependable, crazy reliable unit out there in welding land.
05-17-2014, 10:02 AM #4
Since you have it, is that prince a 6 pin or 7 pin on the amphenol
05-18-2014, 12:08 AM #5Junior Member
- Join Date
- May 2014
It's a 14 pin connector. Of the torpedo interface module.
i was able to get more info out of the mk products.
Theres only 3 wires on the 14 pin connector going into the miller.
and they gave me a diagram.
so now I just need the amphenol connector that goes on my 252 and solder the 3 wires to the new plug and I'm ready to go.
I believe I even have the right number for the plug.