Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 2 of 2
  1. #1
    Join Date
    May 2014

    Default what conductor size for 100 FEET

    I have a new MM211, the manual says "conductor data in this section specifies conductor size (excluding flexible cord or cable) between the panelboard and the equipment. If a flexible cord is used minimum conductor size may increase. 230V single phase, 60 Hertz, 14 AWG, 53 FEET. What conductor size do I need for total of 100 FEET? I have a 100 AMP service box in my shop. Thanks

  2. #2
    Join Date
    May 2010
    Central CA

    Default Cord size

    Try this page 83 in my reader or 79 in the book.
    Looks like 10Ga. will do the job.
    Good Luck,
    Millermatic 252 w/30A
    Big Blue Air Pak
    Ellis 3000 Band Saw
    Trailblazer 302 Air Pak w/ Wireless Remote
    Dynasty 200 DX
    XMT 350 MPa w/S-74 MPa Plus
    Millermatic 211
    Passport Plus
    Spectrum 625 X-TREME
    Lincoln SA-200 Blue Tint Red Face '63
    2-Lincoln SA-200 Red Face '68
    SA-200 Black Face '59
    SA-200 Green Lite '84
    SA-200 Green Lite '80
    SA-200 Red Face '69
    SA-200 Red Face '66
    SA-200 Green Lite '81
    '70 Black Face Round Barrel

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Warning: Function split() is deprecated in /mnt/stor3-wc1-dfw1/357822/357839/ on line 79

Welding Projects

Special Offers: See the latest Miller deals and promotions.