I have a Miller Syncrowave 250 (serial number KF925533) that I bought new back in 1995. It's worked well throughout the years, but I am now having a problem with the amperage control. When using tig negative or stick DC current, it starts out around 100 amps regardless of how low I set the amperage control knob -- at least, I'm guessing it's around there because my welder does not have an amp meter on the panel.
That being said, everything else works alright. I can go to higher amperage just fine, but I can't go to low amperage.
I tried calling the Miller tech support line, and the tech said to check the hall device. Does anyone know how to check it? I would like to know what other people think the issue might be.
Results 1 to 2 of 2
05-07-2014, 12:26 PM #1Junior Member
- Join Date
- May 2014
Miller Syncrowave 250 Repair Help!
Last edited by HarleyRider; 05-08-2014 at 02:30 PM.
05-08-2014, 10:37 PM #2
It means that your machine is running correctly, and your amp probe may be out to lunch. 35 amps running AC stick, I dont know what miniature AC rod would even start at 35 amps