Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 3 of 3
  1. #1
    Join Date
    Aug 2008

    Default Part number for engine wiring harness - TB302?

    Driving to the job site today, I heard my TB-302 cranking. Pulled over and long story short, a squirrel chewed the engine wiring harness almost in half. Right where the harness plugs into the bulkhead connection. I got in at the rear mounting access hole. Made blank covers for the holes today.

    I need the part number for the harness so, I can order a new one. Don't want to splice it.



  2. #2
    Join Date
    Oct 2009
    Northern ND


    Get your serial number and download the correct parts manual.

  3. #3
    Join Date
    Aug 2008
    Orange, TX


    Miller doesn't offer the engine side wiring harness. At least not in their parts break-down. Only the harnesses in the welder/generator.

    Is there enough slack in the wires to allow installing new terminals for the connector?
    MM200 w/spot controller and Spoolmatic 1
    Syncrowave 180 SD
    Bobcat 225G Plus LPG/NG w/14-pin*
    *Homemade Suitcase Wire Feeder
    *WC-1S & Spoolmatic 1
    PakMaster 100XL
    Marquette "Star Jet" 21-110

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Warning: Function split() is deprecated in /mnt/stor3-wc1-dfw1/357822/357839/ on line 79

Welding Projects

Special Offers: See the latest Miller deals and promotions.