Bought a new Millermatic 211 to go with the Syncrowave 200 that I already had. Had to show it off. Everybody has spoken very highly of the 211.
Floor space is tight in my shop, hence the double stack with space in between.
The Millermatic replaced a Lincoln 175HD, which was limited to 1/8 inch material with solid wire. So I have definitely moved up in power; the 211 is rated for 5/16". No, I would not use it to weld 5/16" thick steel, I have stick on the Syncrowave for that, but I would probably weld 1/4 with it.
Results 1 to 3 of 3
Thread: New toy - 211
02-12-2014, 01:56 PM #1Senior Member
- Join Date
- Sep 2009
New toy - 211
02-15-2014, 04:53 PM #2Member
- Join Date
- Jan 2014
- Northern West Virginia
You might want to check those specs.
02-16-2014, 08:05 AM #3
I've run my 211 way beyond it's duty cycle. I've also welded some 3/4" plate with it. Although, I did pre-heat the heck out of it and it wasn't structural. It's been a great machine.Trailblazer® 302 Air Pak™
Miller Dynasty® 350
Millermatic 350P Aluminum
SuitCase® X-TREME™ 12VS
Millermatic® 211 Auto-Set™ w/MVP™
XR-Aluma Pro Gun
Spectrum® 625 X-TREME™
Thermal Dynamics® Cutmaster® 52
Victor Oxy/Acetylene Set