I've got 22 hours on the compressor side of my TB 302 Air Pak.
This morning I wasn't able to increase pressure at all. I was able to start the compressor just fine. The compressor motor kicks in when I turn the CFM knob on.
Oil is coming from the pressure relief valve. I did hold the valve open a bit while the compressor was running. I've done that in the past and only had air come out.
By the time I got back to my shop and fired it up, the pressure was able to be raised. A mechanic checked the compressor oil and said it appeared to be overfilled. I bought this unit new in 2012 and have never added any oil.
Any Ideas? Should I take it in? Possible blown seal?
Results 1 to 5 of 5
Thread: TB 302 Compressor Problem
01-07-2014, 01:31 PM #1
TB 302 Compressor ProblemTrailblazer® 302 Air Pak™
Miller Dynasty® 350
Millermatic 350P Aluminum
Lincoln LN-25 Pro
SuitCase® X-TREME™ 12VS
Millermatic® 211 Auto-Set™ w/MVP™ (Sold)
XR-Aluma Pro Gun
Spectrum® 625 X-TREME™
Thermal Dynamics® Cutmaster® 52
Victor Oxy/Acetylene Set