I have a Miller Dialarc HF Serial # - JG118889 that I am having some problems with.
We switched the machine over to just a momentary switch for TIG welding. We have been using a switch from Weldcraft, however we keep burning them up and going through them about ever 2-3 months.
I've gone through and replaced all the wiring from the receptacle to the switch itself and have installed a new switch....today while in the middle of welding it just cut out and the switch will not control anything.
When the welder is in remote amperage setting and remote connector is off we can get an arc started...but with the remote connector switch on we don't get anything.
Any suggestions on a momentary switch or options would be much appreciated.
Results 1 to 3 of 3
Thread: Dialarc HF problems
12-13-2013, 10:07 AM #1Junior Member
- Join Date
- Dec 2013
Dialarc HF problems