When I turn on machine power and ready light come on. when I cut with it for a little while It stops cutting and the power light Is the only light on and it is blinking . I can do this for about three times, then when I reset it the power light and ready light come on , and without cutting the ready light goes off and the power light blinks . If I shut It off for a while, and then start cutting again It does the same sequence over again.
Results 1 to 4 of 4
01-08-2014, 12:36 PM #1Junior Member
- Join Date
- Jan 2014
Spectrum 2050 power light blinking
01-10-2014, 11:28 AM #2
Sounds like Too much ir pressure, too much air pressure DOES NOT make the unit cut better, actually makes it either not cut at all, or shuts it down.
01-10-2014, 03:09 PM #3Senior Member
- Join Date
- Sep 2005
- 16919 Pole Rd. Brethren, MI 49619
Mine is fussy on occasion, only way to fix it is to change tips.
01-22-2014, 01:14 PM #4
The power light is blinking because either the buss voltage is too high or the main board thinks the buss voltage is too high. I would reccomend taking it to a service station and having it looked at.Tim Lux
Service and Aplications Specialist
Miller Electric Mfg. Co