Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
 
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 1 of 1

Hybrid View

  1. #1
    Join Date
    Oct 2008
    Posts
    2

    Default Older 5 pin tig pulse control

    Have a dialarc HF and the other day I went to go buy a Mic 4 interface control so I could use some 5 pin foot control and finger controls that I have and the guy had pulse control sitting there. Looks much like the PC 300 that I've seen before but older looking and with the 5 pin in and out. It was an estate sale and the guy didn't know much about it I took a chance and grabed it. I'm not sure if its just not meant for the old dialarc or if its not working. Mic 4 is working fine. With pulse hooked up to mic4 and on welder it act the same with no change. Checked the basics on/off switch and power going to and out of transformer seems ok. Any ideas??image.jpg
    Last edited by kevdidy; 09-20-2013 at 01:25 PM. Reason: Move picture

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Welding Projects

Special Offers: See the latest Miller deals and promotions.