Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 2 of 2

Thread: plates

  1. #1
    Join Date
    Jun 2012

    Default plates

    Good afternoon, Have made a couple of driveway ramps for neighorhood due too extra steep driveway incline. Newer cars will bottom out pulling in or out. Using 1/4" x 24" x 48" plate welded end to end to cover full size 2 car driveway (16')

    I have somebody lives on a court with a single car driveway so 8' will be fine. Question is how can I put a curve maybe 5-6 degrees without cutting off and wasting a lot of material ? I was thinking overlap ends then torch off the excess ?? thanks for any help..../gary

  2. #2
    Join Date
    Jun 2009
    las vegas


    Picture. I would make a couple of cuts bend then reweld.
    Syncrowave 250
    Millermatic 210
    dialarc 250
    spectrum 375x
    trailblazer 302
    Lincoln 135

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Warning: Function split() is deprecated in /mnt/stor3-wc1-dfw1/357822/357839/ on line 79

Welding Projects

Special Offers: See the latest Miller deals and promotions.