I have a problem with the following situation: I have to weld a L shape 4”x 10” , 5/16” thick and 6” wide to the bottom part of a W 16x50 25 l.f. which thickness of the flange is 5/8” and wide is 10.25”, is not flush, 5” deep. The rod have to burn the ceiling of this flare-bevel joint and the rounded corner of the flat bar or plate, I think 2 passes would be reasonable, the first overhead to get a lower ceiling and start to close the gap of this joint and the second or third a little horizontal to get a good bond with a 1/8” 7018 rod at 140 amperes. The gap is 1/2" and deep is like 1/4" I’d like to listen commentaries. The diagram tells a lot. Thanks in advanceFLARE BEVEL JOINT GROOVE-NELSON-ACADEMY BEAM W16X50-DETALLE-EXPORT 2D.jpg
View Poll Results: Has to be multiple pass?
- 0. You may not vote on this poll
Results 1 to 4 of 4
Thread: Welding a flare-bevel joint
09-18-2013, 07:44 PM #1Junior Member
- Join Date
- Dec 2008
Welding a flare-bevel joint
Last edited by JULIO; 09-18-2013 at 07:50 PM.
09-18-2013, 07:55 PM #2
You may want to DELETE this post and survey
and then repost it in the WELDING DISCUSSION forum...
not likely to get a lot of response in the MOTORSPORTS forum
to that question...
Last edited by H80N; 09-18-2013 at 07:59 PM..
The more you know, The better you know, How little you know......
“The bitterness of poor quality remains long after the sweetness of low price is forgotten”
Buy the best tools you can afford.. Learn to use them to the best of your ability.. and take care of them...
My Blue Stuff:
Dynasty 350DX Tigrunner
Millermatic 350P w/25ft Alumapro & 30A
TONS of Non-Blue Equip, plus Mills, Lathes & a Rat Tail File..
09-19-2013, 05:14 AM #3
No picture shows up bud.
09-19-2013, 09:06 AM #4
I'll go first. Having no clue what this does or how many you have to do my opinion is 3 passes. Just like you would do any other normal fillet. 1 root pass, 2 fill in bottom, 3 fill in top.
Is this the only weld to hold it on or are you going to weld other sides also?MM250
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24