Have a guy who needs a key welded in the slot of a crankshaft for the pully.
He said he used JB weld to hold it in place for ten years but it finally broke loose and chipped out the side of the keyway slot a little. Guess it was chipped somewhat before the JB.
Its a last ditch effort so I think I'll go Tig it in and fill the chipped area. He wants the key permanent in its slot.
This is a first, and my first thought was warping but I think I can keep the heat down by running a little hot and quick and it will do ok.
Yea, it will be in the car under the hood. No foot peddle just set the amps and lift arc. I just don't how hardened the steel will be or what the best filler is. I'm thinking just some ER 70 S in 1/16.
Results 1 to 4 of 4
09-13-2013, 11:24 PM #1
09-14-2013, 05:55 AM #2
Cast iron crank?
if iron it may be extremely dificult to weld... especially in car...
You might be able to fill with Everdur rather than ER70s-X
But still very difficult in the car..
LOCTITE makes a product designed for just this stuation..
This is a common problem on the Mazda Miata and here is a good thread on the fix..
(Far superior to JB Weld & a PERMANENT Repair)
You might consider it...
Last edited by H80N; 09-14-2013 at 06:18 AM.
The more you know, The better you know, How little you know......
“The bitterness of poor quality remains long after the sweetness of low price is forgotten”
Buy the best tools you can afford.. Learn to use them to the best of your ability.. and take care of them...
My Blue Stuff:
Dynasty 350DX Tigrunner
Millermatic 350P w/25ft Alumapro & 30A
TONS of Non-Blue Equip, plus Mills, Lathes & a Rat Tail File..
09-14-2013, 08:21 AM #3
I think Mazda was mentioned a couple weeks ago when I repaired a chip on a pulley. Plus there was a broken bolt in the crank that was described exactly like the shaft in the links.
Looking at the pics,, it will a tough place to weld.
Thanks for the info.
10-09-2013, 12:42 PM #4
Well its done.
I used the DX200 way down towards the bottom of the engine and couldn't see hardly anything.
He clamped the key where he wanted it and I used the foot pedal with machine on 100 amps. I also used .030 mig wire.
Didn't completely fill the worn area but the key is in good and tight. May need a little filling.
Just waiting to see if it works out for him when he puts in back together. Thanks for the help.