where can I get the gas receiver fitting that goes into the face of the machine as well as the clip to hold it in and the hose to connect to the solenoid? Thanks. Dave
Results 1 to 3 of 3
Thread: maxstar 200dx parts?
08-30-2013, 03:07 AM #1Member
- Join Date
- Aug 2013
maxstar 200dx parts?
08-30-2013, 07:09 AM #2
I would probably look them up in the parts manual...
then order them from Miller4Less....
Parts manual Maxstar 200 Series
Figure 11-3. Panel, Rear w/Components (Figure 11-1 Item 2) Page 124
5 . . . . . . . . . . . . . . . . . . 193649 . . . . Ftg, Gas Barbed 1/4 TBG 5/8−18 Female . . . .. . . . . . 1
Try Miller4Less $16.41
And the clip…
601 . . . . . . . . . . . . . . . . 166560 . . . . Ring, Rtng Ext .500 Shaft X .042 Thk E Style Bowed . . . . . .
Last edited by H80N; 08-30-2013 at 07:53 AM..
The more you know, The better you know, How little you know
“The bitterness of poor quality remains long after the sweetness of low price is forgotten”
Buy the best tools you can afford.. Learn to use them to the best of your ability.. and take care of them...
My Blue Stuff:
Dynasty 350DX Tigrunner
Millermatic 350P w/25ft Alumapro & 30A
TONS of Non-Blue Equip, plus CNC Mill, Lathes & a Plasmacam w/ PowerMax-1000
08-31-2013, 08:07 AM #3
Jersey - Although miller4less is the go to place for most, be advised they have a $10 shipping adder for orders under $100 and a small order charge of $7.95 for orders under $30 so factor that in as well. You can avoid one or both if you order other needed items at the same time to get the total up.MM200 w/spot controller and Spoolmatic 1
Syncrowave 180 SD
Bobcat 225G Plus LPG/NG w/14-pin*
*Homemade Suitcase Wire Feeder
*WC-1S & Spoolmatic 1
Marquette "Star Jet" 21-110