When I built my weldtable the 30" X 40" X 1/2" plate had a 1/2" warp across the 40" length. this is what I did to take care of it cold and it's been dead flat since.
Results 11 to 12 of 12
Thread: Warpage...argh.
-
04-18-2007, 07:15 AM #11
Senior Member
- Join Date
- Jan 2006
- Location
- Albuquerque, NM
- Posts
- 1,788
Last edited by Sundown; 04-18-2007 at 07:20 AM.
Regards, George
Hobart Handler 210 w/DP3035 - Great 240V small Mig
Hobart Handler 140 - Great 120V Mig
Hobart Handler EZ125 - IMO the best 120V Flux Core only machine
Miller Dynasty 200DX with cooler of my design, works for me
Miller Spectrum 375 - Nice Cutter
-
04-24-2007, 08:48 PM #12
Junior Member
- Join Date
- Apr 2007
- Location
- Kansas City
- Posts
- 4
1/2 Plate Warpage Fix
Thanks for the replies. I tried all of the suggestions, however George's solution seemed the most efficient. I'll post some pics when completed.
Thanks to All for your assistance. KirtKirt
Millermatic 200 w Spool
O/A
If your not learning something new, you're going backwards!
Reply With Quote
