Couldn't do this job in the time it was needed before I go to my regular job. Plus I wasn't prepared with the steel I needed. So I had to send it to another shop, that was the best I could help.
Makes me sick. The other side had the same repair with a about 20 inches of flat bar maybe 1/4 thick running down the bottom extending well beyond the crack and as far on the other side as possible. Had 4 inch welds about 4 inches apart on each side of the flat bar. Just approximate to that spec the best I could see at a glance. May have been welding around the crack but still had a visible hole.
So how would you have repaired it?
photo (2).JPGphoto (3).JPGphoto.JPG
Results 1 to 10 of 33
Thread: How would you repair this.
07-26-2013, 01:37 PM #1
How would you repair this.