Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 2 of 2
  1. #1

    Default 350 LX High freq cuts out

    Hey gang. Have a 350LX and the high frequency cuts out after about 20 minutes of use. I pulled the side panel to observe the points and the arc is strong and constant then it just cuts off and if you touch the chassis you get a shock.

    Anyone have experience with this?

  2. #2
    Join Date
    Feb 2013
    Southwestern WV


    Look close at the wiring. I found a wire that had layed on top of a screw and had shorted to the chassis. I just repaired the wire and all was good.
    Syncrowave 350lx
    XMT 350 CC/CV
    S74DX Feeder
    30a spoolgun
    Hypertherm 1000 g3
    Harris O/A
    Cincinnati lathe
    Acer Ultima "Bridgeport Mill"
    340hp Quincy and 400 gallon of air
    Other doodads and a stoker coal stove

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Warning: Function split() is deprecated in /mnt/stor3-wc1-dfw1/357822/357839/ on line 79

Welding Projects

Special Offers: See the latest Miller deals and promotions.