Hey all. New guy here!!
I have an older Hobart fabricator 300a power source that I run my xr 30 push pull mig with. Both units use the 6 pin connector.
I found a sweet deal on a series 60 wire feeder. But before I buy it would like to know if I can run the 60 off of my pwr source? The 60 has a 14 pin connector but it only has a jog switch and wire speed dial, all other options are blanked out. Much like my xr30!
Can the 14 pin unit be modded to run on the 6 pin pwr source ?? Thanks. Dan!!
Results 1 to 6 of 6
05-06-2013, 07:37 PM #1
newbie. with series 60 & power source question!!