Using a Millermatic 350/P... I've got to follow the parameters of an approved weld procedure specification pretty close, namely Amps, Volts and Wire Feed Speed.
I can see how to adjust Volts and Wire Feed Speed, however how can I adjust the amperage, and how do I see the machine is actually operating within the amperage range I need to stay within according to the WPS?
Other welding machines I've used in the past had dials and gauges for both Amps and Volts.
Results 1 to 2 of 2
04-29-2013, 04:49 PM #1Junior Member
- Join Date
- Apr 2013
Millermatic 350/350P and Weld Procedure Specification
04-30-2013, 02:57 PM #2
6-4. Weld Status
When trigger is released on a MIG gun, spool gun, or push-pull gun, the last actual amperage and voltage will be shown on the displays for 5 seconds. The VOLTS and AMPS indicator lights will illuminate under the displays and each value will appear in the corresponding display.
If a programmed value requires adjustment after the arc is extinguished and during the 5 seconds display of actual values, turning either knob will cause actual values in the displays to be replaced by programmed values for adjustment purposes.
Passport Plus w/Spool Gun
Miller 125c Plasma 120v
SO 2020 Bender
You can call me Bacchus