I made this so I could roll the saw outside. I centered the motor over the 4" sq tube riser so down forces would go straight to the floor to help with balance when cutting. The angle irons end over the center of the axle. The handle slides in out of the way. For those that don't know, you can click on the double lines down at the bottom left by the pictures and stop the slide show and see the pictures one at a time by clicking on the arrows on the screen.
Results 1 to 10 of 19
Thread: simple chopsaw stand
04-29-2013, 12:38 PM #1
simple chopsaw stand
Last edited by tackit; 04-29-2013 at 12:44 PM.
04-29-2013, 03:49 PM #2
I have never seen any of your pics. When i click on the link u paste it sends me to a sign in page. Am i the only one?
04-29-2013, 03:50 PM #3
Also... it may be cause im on here with a stupid.. i mean smart phone
04-29-2013, 03:57 PM #4Senior Member
- Join Date
- Apr 2009
- Upstate SC
Pics work fine for me. Nice stand.
CGOld Miller Swinger 180 Buzzbox
Miller Diversion 165
1945 Craftsman Atlas Lathe
04-29-2013, 04:11 PM #5
04-29-2013, 04:13 PM #6
Weldon, I have it set to public, it should be showing up on your dumb phone.
04-29-2013, 04:14 PM #7
04-29-2013, 05:35 PM #8Originally Posted by tackit:306908
04-29-2013, 05:42 PM #9Originally Posted by tackit:306909
04-29-2013, 05:47 PM #10
This is with the new bobcat and a hf-251d. No pedal, no on/off switch.. just a hot torch and a gas valve.