If you should need to make a handle a 1" EMT conduit is a perfect drive on fit over a 3/4" BP nipple.
I beveled the 3/4" nipple's edge, laid the blade down on the welding table with the 3/4" angle iron flange looking down and could only drive the 1" EMT on the nipple about two inches with my 8 lb sledge. It didn't need to be welded or bolted on the handle fits so tight. I think what stopped it from going on farther is the shaved galvo on the inside caking up.
Results 1 to 3 of 3
04-21-2013, 03:34 PM #1
I needed a sod cutter so I brought out the plasma and the MM180
Last edited by tackit; 04-21-2013 at 03:43 PM.
04-22-2013, 05:25 PM #2Member
- Join Date
- Dec 2012
- Front Royal, Va
Looks real nice. Always nice to save money and having made something you can use........Fireman Bill
04-23-2013, 01:17 PM #3
Thanks Fireman Bill, it's simple but a good project for guys just starting to weld.