Miller Electric

Welding Discussion Forums

Home » Resources » Communities » Welding Discussion Forums
Miller Welding Discussion Forums - Powered by vBulletin

Results 1 to 2 of 2
  1. #1
    Join Date
    Mar 2009
    Western Mass

    Default Millermatic 200 wire feed problems 2

    Hey Cruizer, can you offer any advice here?

    Having some wire feed problems with my mm-200
    serial jf958985
    using the circuit diagram b-093 009-a
    i only have a single circuit breaker inside the wire compartment and a single fuse on the front panel

    reviewed the mm wire feed threads, found the thyer thread most useful
    but, need something more than is there

    this had some previous work done at a shop before i got the unit, a few splices, it worked fine for a while, but now symptoms below

    pull the trigger, will strike an arc, gas comes on, cr1 works, cr2 does not work, can weld, but wire is intermittent
    both sr1 and sr2 are ok, main contactor working
    cr2 does not work, but, has 36 volts to it
    changed cr2, still not working
    no power to wire motor

    i have occasionally been able to get wire feed to work but the cr2 relay does not move when that happens

    not sure about the cb1, it seems popped out and does not seem to want to reset, but, has continuity between 2 adjacent pairs of posts

    would like to make sure the wiring on cr2 is correct, but, not sure how to read the diagram ... which wire numbers go to which pole on the relay?

    any thoughts out there?
    Last edited by canoepc; 04-16-2013 at 05:27 AM. Reason: more detail

  2. #2
    Join Date
    Mar 2009
    Western Mass


    Cruizer can you offer any help here?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Warning: Function split() is deprecated in /mnt/stor3-wc1-dfw1/357822/357839/ on line 73

Welding Projects

Special Offers: See the latest Miller deals and promotions.