I'm getting much better at watching the puddle and throttling the arc, not there yet but getting better!
But I'm roasting my fingers! I know I'm holding the torch too close to the tip on the right side and I still can't feed the rod smoothly on the left so my beads end where I can't hold it anymore. I'm laughing about it cuz I know I'm just dumb but I thought other beginners might enjoy my plight.
The good news is I'm getting better!
Results 1 to 2 of 2
Thread: TIG's roasting my fingers
03-09-2013, 01:50 PM #1
TIG's roasting my fingersMiller Diversion 165
1966 Bridgeport Mill
Leblond 15x 35 Regal Servoshift lathe
Solberga SE 1425 Drill Press
small surface grinder
Tons of grinders and hand tools
Knife edge Balancing rollers
Heat and AC in the garage
Jags and racing Triumphs