well I started tearing down my Miller bobcat welder..for a restoration project today. Got all the cowling off and covers.will pressure wash it tomorrow and then be ready to sand a paint...got all the new decals and grafix in for it , so it should look like a new done... dont know weather to wash the electrical parts , there are no circuit boards in it to ruin but im Leary of that , may just have to wipe that part down with a damp rag, the motor im not worried about. will post before and after pics later. anyone have any suggestions......Its a BoBcat 225G Plus with an Onan, i dont see any circuit boards in it .....will it hurt the transformers and switches if i did a quick wash and then blow dry with air. any input would greatly be appreciated Thanks