I got a syncrowave 350 lx. When I plug the pedal in the high frequency comes on and stays on for a minute and shuts down and HLP 10 appears. Anyone know where the problem may be?
Results 1 to 3 of 3
Thread: Pedal issues
03-03-2013, 06:00 PM #1
Pedal issuesThe machine is only as good as it operator.
03-03-2013, 07:00 PM #2Member
- Join Date
- May 2003
I believe HLP10 is "remote output control is activated, release output control to clear help message"
It sounds like your pedal is stuck slightly on. So you probably have output at your torch; be careful.
Does the machine operate properly without the pedal? Has the pedal been damaged, slammed, dropped?
When I bought my syncro 250 I had the same problem. Someone dropped the pedal and bent it enough to activate the internal switch where the machine thought it was welding when ever the pedal was connected. Thankfully my older syncrowave doesn't have a built in computer and I just bent the pedal back into shape. All was well.
Did you try clearing the machine's help function?
03-05-2013, 08:53 AM #3
I got it fixed. The micro switch was bent just a hair. Thanks for helping me out.The machine is only as good as it operator.