Thanks. I washed down the garage last week and now it should stay clean. I hate a dirty garage. Now if only I could get my wife to stop parking in my shop...that way I'd have room for a few more tools!
Results 11 to 20 of 23
03-11-2013, 01:55 PM #11
03-18-2013, 10:35 AM #12Senior Member
2007 Miller Dynasty 200 DX
- Join Date
- Nov 2008
- Atl, Ga
2005 Miller Passport 180
03-18-2013, 11:16 AM #13
Let me just run that past the wife and see how see likes it. Naturally, I would put it on her side of the garage. I think it would look great over there. I could put some lacy stuff around it for her. Seriously, that's a great idea, but...
03-19-2013, 12:33 AM #14
Nice project. What about venting it through the roof? You know, put a cap on it like ya do for a furnace or stove.Professional firefighter (retired). Amateur everything else I try to do...
Oh yeah: GO BIG RED!
03-19-2013, 07:34 AM #15
That would work. I have an attic above the garage. A vent could be run up into the attic and then out the roof. Now that's something that's feasible. Thanks for the idea. I'll have to ponder that one...
03-19-2013, 09:38 AM #16Senior Member
- Join Date
- May 2011
- Bossier Parish La.
The fan set up you have made looks very handy. One suggestion that comes to mind is to rig the two outer fans to one switch and the center one to it's own. This gives you the option of using 1, 2, or 3 fans at a time depending on needs at the time.
03-19-2013, 12:11 PM #17
She got a kick out of that! The dual switches is a good idea. Isn't it great when people are left alone to their own ideas and the suggestions of others?
03-19-2013, 01:15 PM #18
Google replacement Lincoln activated carbon filter. They have one that is shaped like a box for $56, you could probably rig that up to work with your fans??
03-19-2013, 02:04 PM #19
I'll check it out. Thanks...
03-19-2013, 02:30 PM #20Senior Member
- Join Date
- Feb 2012
Don't run it through the roof. I'm a general contractor and I can tell you from experience. It is much more difficult to keep watertight. I would look into running through an exterior wall if possible, or pop into the attic and then route up against the backside of an attic vent ( gable end vent, ridge vent, or bird block). I try to avoid retro fitting pipes through any roofing material as its almost impossible to do it properly.