Black wire off the drive motor isnt plugged in anywhere. Ive looked all through owners manual for a clue. Schematics i have dont show. Any help would be greatly appreciated. P.S. This is my first post on this forum!
Results 1 to 4 of 4
Thread: Millermatic has a loose wire
-
02-27-2013, 04:54 PM #1
Junior Member
- Join Date
- Feb 2013
- Posts
- 2
Millermatic has a loose wire
-
02-27-2013, 05:28 PM #2
Senior Member
- Join Date
- Oct 2004
- Location
- Edmonton, Alberta
- Posts
- 6,750
A millermatic what?, there are many, a serial# to pull up the correct diagram would be handy too
-
02-27-2013, 06:06 PM #3
Junior Member
- Join Date
- Feb 2013
- Posts
- 2
Millermatic 35. Serial number JH212708.
-
02-27-2013, 07:11 PM #4
Senior Member
- Join Date
- Oct 2004
- Location
- Edmonton, Alberta
- Posts
- 6,750
They both wind up at CR1 relay. one goes to a brake resistor (stops the drive from turning once the gun trigger is released) Normally closed portion of CR1 relay
The other goes to the Normally open part of CR1 relay, once energised the motor turns.
Reply With Quote
