Very unlikely its a Serial# HK, as these units were not around then, perhaps a KH sounds better.
As I said, if the top board fails, its like $700 to buy a replacement. Best to merely send it out to a repair shop. which would cost around the $300 mark
Results 11 to 13 of 13
Thread: XMT 304 Problems
-
02-11-2013, 06:59 PM #11
Senior Member
- Join Date
- Oct 2004
- Location
- Edmonton, Alberta
- Posts
- 6,752
-
02-17-2013, 08:59 AM #12
Junior Member
- Join Date
- Feb 2013
- Posts
- 10
Brought the machine to a new shop, they replaced the high frequency transformer in the bottom of the unit. They said that there was a pinched wire and when the frequency spiked it would arc across the windings. took the machine home and no change.
Would love to solve this problem as right now I have a $1800 piece of garbage sitting in my shop
Frank
-
02-17-2013, 09:01 AM #13
Junior Member
- Join Date
- Feb 2013
- Posts
- 10
2 different shops have now gone through the machine, both have said that the board is fine but said that a replacement isn't made anymore
Reply With Quote
