I have a '05 300DX
Its been sitting for a while, not much use. Been stored while setting up new building / shop.
I fired it up a few days ago and two things caught my attention.
1. The little blue indicator that rotates was not rotating.
2. The CoolMate3 was making a noise.
anyone have suggestions?
I'm thinking I need to take the torch head apart far as possible an clean it out. I think it may have debris clogging it. I have not done this before.
I have replaced fluid once sense I got the machine in '05.
The fluid is as clear as the day I changed it out last.
it should still be good right?
Results 1 to 5 of 5
Thread: TIG: Dynasty 300DX - Problems
01-16-2013, 07:37 PM #1Junior Member
- Join Date
- Jan 2013
TIG: Dynasty 300DX - Problems