I have a newer Bobcat 250 at work that has everyone stumped. It is the only gas welder we have. I am a diesel mechanic which is good because we have 20 diesel welders but only one gas SN# MA180071h . The motor doesn't run it cranks, sparks, and I have fuel after the fuel pump is there something I am missing? I can get it to fire and run for a moment on starting fluid. if i poor gas in the carburetor it will sputter and run for a minuet then die. The carburetor is clean. The motor is a Kohler SN# 4013403941. Is there some kind of electric shut off or something. Thank you in advance.
Results 1 to 10 of 12
Thread: Bobcat 250
12-12-2012, 08:16 PM #1
12-12-2012, 08:19 PM #2
What about the low oil shut off switch, could this be the culprit?
12-12-2012, 08:20 PM #3
I know it has oil but how does the switch work? Stop spark? because I have spark? How would I test it?
12-12-2012, 08:40 PM #4Junior Member
- Join Date
- Dec 2012
My honda on my compressor was doing the same thing. I thought my carb was clean. I was wrong. Took carb apart, pulled float needle and ran a piece of wire ( from a twist tie off a loaf of bread ) thru the tube . Put back together and it fired up first pull. All this done after i sprayed a whole can of good carb cleaner thru it and it still wouldn't run. If you are getting gas to the bowl that may be your problem
12-12-2012, 08:40 PM #5
I remember reading on the forum that if the switch failed it could cause the unit not to start. I could be wrong, but I seem to remember something like that. Maybe we could do a search. I am sure tomorrow when Cruizer or Duane sees this you will get your answer.
12-12-2012, 09:15 PM #6
Thanks Nick yea I'm hoping its something like that. I am not a small engine guy. I don't think it's the carburetor one of my coworkers cleaned it. I didn't take the carb apart myself but he is pretty reliable. I forgot to mention the welder has less than 125 hours on it.
12-12-2012, 09:22 PM #7
Try bypassing the low oil switch.MM250
Lincoln ac/dc 225
MM200 black face
Whitney 30 ton hydraulic punch
Lown 1/8x 36" power roller
Arco roto-phase model M
Vectrax 7x12 band saw
Miller spectrum 875
30a spoolgun w/wc-24
12-12-2012, 09:25 PM #8
Just behind the carb sits the fuel shutdown solenoid, perhaps the wire that runs it came off.
Nothing to do with oil pressure switch, as you wouln't get any spark
Last edited by cruizer; 12-12-2012 at 09:33 PM.
12-12-2012, 09:34 PM #9Senior Member
- Join Date
- Dec 2004
Engine won't start
You can go to opeengines.com and download the manual for that engine or look at the parts breakdown for free, they are a online kolher dealer.
12-13-2012, 06:34 AM #10Senior Member
- Join Date
- Dec 2007
Easy to clean if gummed up and easy to replace if corroded.
If gummed up, sometimes you can tap on the solenoid while the engine is being cranked and get it unstuck.
Last edited by griff01; 12-14-2012 at 08:37 AM. Reason: clarification