Hi all
Finally got the Dynasty fired up.However it shows a "low line" error code and thats as far as i can get with it.
I'm in the UK so i guess it may have something to do with the difference between OUR single phase setup and US single phase setup.
Anyone got any ideas what i would need to do to get this resolved?
The electrician that came and wired it up from my DB confirmed that there was 234V at the machine,so i dont know whats wrong?
Help GREATLY appreciated (Cruizer,you like a challenge!)
Results 1 to 10 of 14
Thread: Dynasty electric set up IN UK
Hybrid View
-
12-09-2012, 08:07 AM #1
Junior Member
- Join Date
- Oct 2012
- Posts
- 10
Dynasty electric set up IN UK
-
12-09-2012, 10:25 AM #2
Senior Member
- Join Date
- Oct 2004
- Location
- Edmonton, Alberta
- Posts
- 6,751
Did you use the black and white wires at the machine?
-
12-09-2012, 11:23 AM #3
Junior Member
- Join Date
- Oct 2009
- Location
- 595 Riverside
- Posts
- 13
I've been running my Dynasty on European power with no problems.
-
12-09-2012, 12:31 PM #4
Junior Member
- Join Date
- Oct 2012
- Posts
- 10
@ cruizer
Yes sir,
Black on top and white second...no red attached
-
12-09-2012, 12:32 PM #5
Junior Member
- Join Date
- Oct 2012
- Posts
- 10
How was power connected @ input panel?
Originally Posted by Guardrail
Thanks
-
12-11-2012, 02:08 AM #6
Junior Member
- Join Date
- Oct 2012
- Posts
- 10
Help!!!
Anyone?????
-
12-11-2012, 09:07 AM #7
Senior Member
- Join Date
- Oct 2004
- Location
- Edmonton, Alberta
- Posts
- 6,751
Whats the serial#
check your phase to phase voltage, these units don't care about the freq, and they will run fine anywhere
Reply With Quote
