My new weling cart / table

[Rufridr069]

Finally finished my new welding cart/table. Of course painted True Blue.

[jarto017]

Very nice indeed. I've thought about a combo cart/ table but probably only for tig because I'm too **** to burn up my welder covers! Nice touch with the beer holder! What color blue is, that sail blue rustoleum?

[Rufridr069]

Very nice indeed. I've thought about a combo cart/ table but probably only for tig because I'm too **** to burn up my welder covers! Nice touch with the beer holder! What color blue is, that sail blue rustoleum?

I thought of that too. I think I am going to put some side covers where the welder is to keep it from getting burned. Also going to make some fenders for the rear wheels. And yes it is Sail blue rustoleum.

[millerpro]

Hi,
I am building me a table also and could not decide how thick the top should be. how thick is your top. also did you tape up the top while you painted it.

Thancks, Eric

[JonnyTIG]

I just built a new welding table, but it is not in cart form. I used 1.5" 44W for the top, so it could be used for a jig table. I work with heavy equipment, sometimes in excess of 10 tons, and I need to have the abillity to anchor projects securely while working on them. A thicker table top allows you to drill and tap holes for clamping, and resists distortion.

[fyoung]

That's some table! What does that sucker weigh?
I'm sure it will come in handy and you won't have to worry about anyone walking off with it *LOL*
Farris

[Rufridr069]

Hi,
I am building me a table also and could not decide how thick the top should be. how thick is your top. also did you tape up the top while you painted it.

Thancks, Eric

The top is 3/8 cold rolled steel 20"x42"

Don't laugh.....I painted the frame then ground off the paint where the frame would be attached to the top. I laid the top on the floor upside down and put the frame on top of that and welded them together. I wired off the welds then sprayed them blue before i flipped over the table on it's wheels.

And i think it weighs a good 250#

[millerpro]

i am trying to keep costs as low as posible so i checked the prices at the metal shop. i was thinking about 1/4 in but they recomended that to keep the costs low i should use 16 gauge sheet. they said it would be about as thick as the fenders of a trailer. i thought that would be pretty strong but if you hammer something on it it would make dents. would 1/4 inch be too thin. it was $110 for a 4x8 sheet. the 16 guage was $45 for a 4x8 sheet. i only need about a 4x4 sheet so i asked if they could sell me half of a sheet and they said that they used to but now most everyone wants a full sheet. also thanks for the painting info. i want the table to look good but still conduct electricity so i will do that.

Thanks, Eric