Looking at a 2006 XMT 350 CC/CV, supposedly with low hours. It's over 6 years old now, did these machines have any problems that were fixed in subsequent model years? The owner says it's a "second generation" XMT. I can't find any history on these in the bit of web searching I've done.
PS: tried to search the forums, but can't figure out how to get past the 4 letter search term minimum. or at least that's what i think is getting me no hits.
Results 1 to 3 of 3
12-07-2012, 12:00 PM #1Junior Member
- Join Date
- Apr 2007
XMT 350 CC/CV history, issues, problems? Looking at a 2006 unit....
Last edited by montejw; 12-07-2012 at 12:35 PM.
12-07-2012, 02:30 PM #2
As long as you won't be having it running on big power like 575, it'll be ok.
Also when you buy it, take the top cover off and tighten the backs of the output studs. You should be fine.
12-08-2012, 12:34 AM #3Senior Member
- Join Date
- May 2006
Buy a torque wrench that is adjustable in inch/lbs. and get a copy of the shop manual for the welder if you can't find the studs or the correct torque setting. Consult cruizer about the manual if you need it.Miller XMT-350 CC/CV
Miller S-22A wirefeeder
Bernard 400A "Q" gun
Miller 30-A Spoolmatic w/WC-24
CK 210 & WP-18 GTAW torches
Hypertherm Powermax 30
O/A Rig, Enco 4x6 bandsaw, etc.