Does anyone have any ideas about how to weld a piece of 24 gauge SS? This is a long piece of trim from a classic car. It needs about a 1/4 inch weld.
I tried using a Dynasty 350 on 5 amps. Too hot when the arc starts and not hot enough once it stabilizes. Tried using heat sinks to keep the heat away from the trim. Tried pulse. No luck.
Results 1 to 9 of 9
Thread: 24 gauge stainless help
11-29-2012, 10:00 AM #1
24 gauge stainless helpTrailblazer® 302 Air Pak™
Miller Dynasty® 350
Millermatic 350P Aluminum
Lincoln LN-25 Pro
SuitCase® X-TREME™ 12VS
Millermatic® 211 Auto-Set™ w/MVP™ (Sold)
XR-Aluma Pro Gun
Spectrum® 625 X-TREME™
Thermal Dynamics® Cutmaster® 52
Victor Oxy/Acetylene Set