New to the forum and the welding trade. Just purchased the MM 211 and have used it to build a welding table. The welder seems to be working just fine as far as the beads im laying down, but the machine seems to make a lot more noise from the wire spool drive or wire drive rolls. Is this normal from the MM 211's or is this a problem. Previously welded with a Lincoln wire feed that didnt make this much noise. Any feedback welcome!
Results 1 to 4 of 4
Thread: Millermatic 211 question
11-28-2012, 03:51 PM #1Junior Member
- Join Date
- Nov 2012
Millermatic 211 question
11-28-2012, 07:17 PM #2
Couldn't tell you without hearing it..
Miller Bobcat 225NT onan
(Retapped to fit regular mig tips)
Work better & less parts to stock.
T/A Dragster 85 (portability 11 pounds)
Oxygen/Acetylene torch set 50'
2. 4-1/2" grinders
1. 9" grinder
14" Makita chop saw
1/2" Aircat impact gun 900#
11-28-2012, 07:29 PM #3Senior Member
- Join Date
- May 2012
I just ran mine tonight and didn't hear what I felt was much sound if any. Is the wire spool cranked down a bunch making the noise? Or does it sound more like a drive motor sound?
11-28-2012, 07:30 PM #4
Is kind of a squeeling noise? If the wfs is cranked is does that.