I just picked up a Syncrowave 180 SD (2001 model without digital read out) . High frequency does not work. I did scratch start TIG and it welded fine. Prior owner said it has damage on the board and he had taken the board to a welder service-they said it was not repairable. Anyone had good results with a board (card) repair? The new boards are really expensive. I would like to repair it so I can use the TIG AC. Or I could just use it with what still works and get another unit with AC TIG. Thanks, Matt Are used boards available?
Results 1 to 3 of 3
Thread: Syncrowave 180 SD problem
Threaded View
-
11-25-2012, 10:47 AM #1
Junior Member
- Join Date
- Jul 2010
- Posts
- 2
Syncrowave 180 SD problem
Last edited by matt56; 11-25-2012 at 01:10 PM.
Reply With Quote
