Hi,
I want to practice on some 1/4 steel plates with my 130XP. I would like to know what wire speed and amp number I should start off with. Also what number I should set the gas regulator to. Does the main tank valve always get opened up all the way with the only pressure adjustment being on the regulator itself? Any good advice would be deeply appreciated
Results 1 to 3 of 3
Thread: Millermatic 130xp settings
Hybrid View
-
11-12-2012, 12:56 PM #1
Junior Member
- Join Date
- Nov 2012
- Posts
- 2
Millermatic 130xp settings
-
11-12-2012, 01:27 PM #2
Senior Member
- Join Date
- Dec 2007
- Location
- Los Angeles
- Posts
- 2,636
http://www.millerwelds.com/om/o1316f_mil.pdf
The manual has the suggested settings for the machine.
Yes, open the Tank valve all the way but open slowly and then all the way.Ed Conley
http://www.screamingbroccoli.net/
MM252
MM211
Passport Plus w/Spool Gun
TA185
Miller 125c Plasma 120v
O/A set
SO 2020 Bender
You can call me Bacchus
-
11-12-2012, 06:31 PM #3
Member
- Join Date
- Nov 2012
- Location
- Washinton
- Posts
- 56
Double check, but I do not think the 130 is rated for 1/4 single pass welds, multible passes or both sides maybe with bare wire. I believe they rate it for 1/4 plate with a flux cored gasless wire. In fact even with E71T-GS it says 3/16
Reply With Quote
