Have use this gun frequently, with a 211...but never with steel wire (NOT flux-core), always with aluminum.
Will this gun run steel wire with the 200?
And can I use ARGON...instead of CO2, since I have Argon in abundance?
Results 1 to 7 of 7
Thread: MillerMatic 200 + SpoolMate 100
11-10-2012, 02:32 PM #1Junior Member
- Join Date
- Nov 2012
MillerMatic 200 + SpoolMate 100
11-10-2012, 02:39 PM #2
Steel works fine with any spoolgun, though if your a welder, you should know better on the Argon issue
11-10-2012, 05:39 PM #3
Sunrise Outside My Shop In Delhi, Ontario
- Arcair- K 4000 CAC.
- LN-25 Wire Feeder
- Lincoln Ranger 8- Engine Drive- CC\CV:
- Lincoln Power Mig 180C
- DeWalt Chop Saw .
- DeWalt Compressor - 13cfm, @ 100 psi.
11-10-2012, 06:31 PM #4
I think the bigger question is how are you going to run the Spoolmate 100 on a MM200. Just my thoughts...BobBob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
11-10-2012, 08:59 PM #5
About the only way would be coupled to an SGA 100 with a modified control cable plug to fit the MM200 4 or 14-pin spoolgun control receptacle depending on its generation.MM200 w/spot controller and Spoolmatic 1
Syncrowave 180 SD
Bobcat 225G Plus LPG/NG w/14-pin*
*Homemade Suitcase Wire Feeder
*WC-1S & Spoolmatic 1
Marquette "Star Jet" 21-110
03-23-2013, 09:32 PM #6Junior Member
- Join Date
- Mar 2013
03-24-2013, 10:24 AM #7Ed Conley
Passport Plus w/Spool Gun
Miller 125c Plasma 120v
SO 2020 Bender
You can call me Bacchus