I have a 5' x 10' single axle utility trailer and am getting wear only on the outer edge of the tires. I have not yet measured camber or toe-in. Can someone tell me if a trailer of this size should have straight toe-in or not?
Results 1 to 5 of 5
Thread: utility trailer alignment
-
05-02-2012, 02:08 AM #1
Junior Member
- Join Date
- Oct 2010
- Location
- Wa state
- Posts
- 4
utility trailer alignment
-
05-02-2012, 02:40 AM #2
Senior Member
- Join Date
- Sep 2005
- Location
- Salem ,Ohio
- Posts
- 3,671
You prob have camber where the axle is pre bent in the center but you should have no toe in unless the spindle is bent. Look under at the top of the axle and see if its humped a little...Bob
Bob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
-
05-08-2012, 04:13 AM #3
Junior Member
- Join Date
- Oct 2010
- Location
- Wa state
- Posts
- 4
utility trailer alignment
Yes it was cambered. It had about 5/16" bow in the middle of the axle. I heated it up and tried bending it. got it perfectly straight on the first try. Thanks!
-
Today, 09:07 PM #4
Junior Member
- Join Date
- May 2013
- Posts
- 21
I think its supposed to be bent/ cambered!!!
-
Today, 09:22 PM #5
Junior Member
- Join Date
- Nov 2012
- Posts
- 13
Lol. Omg!
Reply With Quote
