Hi, I need some help. I have a Millermatic 130xp and I want to practice some welds on some 1/4" steel plating. I need to know the regulator, wire speed, and amp settings I should start off with. I can adjust the other settings accordingly as I go but I need to also know if the gas regulator setting always remains the same no matter what you are welding. Thanks
Results 1 to 3 of 3
Thread: settings
-
11-12-2012, 12:26 PM #1
Junior Member
- Join Date
- Nov 2012
- Posts
- 2
settings
-
11-12-2012, 03:07 PM #2
Senior Member
- Join Date
- Jun 2012
- Location
- Tracy, CA
- Posts
- 175
Here's the manual for the 130XP.
http://www.millerwelds.com/om/o1316f_mil.pdfTrailblazer® 302 Air Pak™
Miller Dynasty® 350
Millermatic® 252
Syncrowave 351
SuitCase® X-TREME™ 12VS
Millermatic® 211 Auto-Set™ w/MVP™
Spoolmate™ 100 Series
Diversion™ 180
Spectrum® 625 X-TREME™
-
11-12-2012, 03:17 PM #3
Senior Member
- Join Date
- Sep 2005
- Location
- Salem ,Ohio
- Posts
- 3,654
I think you should drop down to 1/8" or under to practice on. 1/4" will be pretty tough for that little welder...Bob
Bob Wright, Grandson of Tee Nee Boat Trailer Founder
Metal Master Fab Salem, Oh 44460
Birthplace of the Silver & Deming Drill
1999 MM185 w/185 Spoolgun,1986 Thunderbolt AC/DC
Reply With Quote
