T1 Transformer

[cruizer]

Yep, You'll see a couple of wires together in your t1 transformer with #'s 15 & 6. see if they are closed, if not you could always jumper them out.

[eww]

I think the 130 has an overlaod protector protector TP1 at the T1 transformer, if it is faulty fan will run but not weld output.

Here is your sechmatic.

http://www.millerwelds.com/om/o1316f_mil.pdf

Thanks much, what does the italicized numbers, (1, 2, 3, 5, 15, etc) relate to?

[cruizer]

There are #'s on the wires.

[eww]

There are #'s on the wires.

Machine started working after I removed the blade connector from the overload componant. Looking at the side of machine, the wire at top of the overload componant was removed to check voltage and when I reconnected the lead and pressed the trigger on gun the drive motor started working.

So much for a Authorized Repair facility

[cruizer]

Well thats FANTASTIC NEWS!!! Its tough to t-shoot over the net especially when there is wires off vital components.

But I'm super glad its working again!