I need a T1 transformer for a miller 130xp (part # 210000) serial # KK276783
Results 1 to 10 of 25
Thread: T1 Transformer
-
10-25-2012, 11:50 AM #1
Junior Member
- Join Date
- Oct 2012
- Posts
- 11
T1 Transformer
-
10-25-2012, 11:52 AM #2
Senior Member
- Join Date
- Oct 2004
- Location
- Edmonton, Alberta
- Posts
- 6,765
Yeah,,,, not happening, Where is the winding broken" Can you see the break?
-
10-25-2012, 09:00 PM #3
Senior Member
- Join Date
- Aug 2008
- Location
- Orange, TX
- Posts
- 1,058
You could give Larry Burross (member weldersales) a call to see if he can help out with a NOS or used unit.
Applied Equipment, Inc.
2515 Cartwright St.
Dallas, Tx 75212
214-630-9353 phone
214-630-9354 fax
888-630-9353 toll-free
214-577-9353 cell
Email: weldersales@airmail.netMM200 w/spot controller and Spoolmatic 1
Syncrowave 180 SD
Bobcat 225G Plus LPG/NG w/14-pin*
*Homemade Suitcase Wire Feeder
*HF-251D-1
*WC-1S & Spoolmatic 1
PakMaster 100XL
Marquette "Star Jet" 21-110
-
10-26-2012, 04:35 AM #4
Junior Member
- Join Date
- Oct 2012
- Posts
- 11
T1 transformer
A Miller repair service repersentative gave me the information that the T1 Transformer was bad.
Originally Posted by cruizer
-
10-26-2012, 06:05 AM #5
Senior Member
- Join Date
- Oct 2004
- Location
- Edmonton, Alberta
- Posts
- 6,765
Reallly, that would be EXTREMELY rare, what was the original problem.
-
10-26-2012, 06:17 AM #6
Junior Member
- Join Date
- Oct 2012
- Posts
- 11
T1 Transformer
Was in the act of welding and wire stoped feeding. Fan runs but no voltage to feed wheel motor. Originally Posted by cruizer
-
10-26-2012, 07:14 AM #7
Senior Member
- Join Date
- Jul 2010
- Location
- Four Flags city
- Posts
- 239
Try here,
http://www.vpartsinc.com/
They sell Miller NOS parts.
-
10-26-2012, 07:59 AM #8
Senior Member
- Join Date
- Oct 2004
- Location
- Edmonton, Alberta
- Posts
- 6,765
Well, thats possible then, same question applies then, can they see the break. Easy fix if they can.
-
10-26-2012, 08:33 AM #9
Junior Member
- Join Date
- Oct 2012
- Posts
- 11
T1 Transformer
The welder is in shop 50 miles from my residence. If the break can be seen can the wire coil be soldered. If yes, I can do that and save labor cost. Originally Posted by cruizer
-
10-26-2012, 10:20 AM #10
Senior Member
- Join Date
- Oct 2004
- Location
- Edmonton, Alberta
- Posts
- 6,765
Crimping would be best, Never the less, its going to be one of those Not Economical to Repair units.
Reply With Quote
